XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I would like to know if there is any easy way to add a protection for short circuit between led+ and led-? It happens quite too often that we destroy either the diode or Rset during the assembly ...

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

I'm attempting to create a dual integrator to measure distance from an accelerometer. We have the ACF2101 but we need a larger capacitor for the integration time which is 2 seconds. Schematic is here.

Hi，I am using the bq40z50-r2 chip for 2S1P battery packs. I now want the battery pack to be able to actively turn on the discharge MOS when plugged into the power supply device, and then automatically ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.